-
**Describe the bug**
'load actual' in predbat is much higher than the GivTCP sensor value.
History of predbat.load_energy_h0
![image](https://github.com/springfall2008/batpred/assets/58569471/04643…
-
I believe that Eco(Paused) just sets Battery Power Reserve to 100% in order to disable discharge. It would appear though, that 100% is not a valid setting for Battery Power Reserve, either from HA or …
-
I run GivTCP in its own Docker container, rather than as a HA Add-on. I am trying to upgrade from 2.2.4 (which works) to 2.4.1
I get a fail, with the following error:
```
06/11/2023
11:48:53
…
-
The current config can’t handle the octopus flux tariff. Flux gives you 4 time periods (02:00-5:00,5:00-16:00,16:00-19:00 & 19:00 to 02:00).
it also has 3 import prices and 3 export prices.
http…
-
Hi, hoping someone can help me. I've created a new docker stack and the container is up and running, however it won't connect to the inverter. I've connected to the docker container and confirmed it c…
-
* GivEnergy Modbus version: Downloaded today 9th June
* Python version: 3.11
* Operating System: Windows 11
### Description
Unable to connect to the All In One on GivTCP, or directly from Wind…
-
**Describe the bug**
The manual force idle function does not pause the battery from discharging - I expected that the battery would neither charge/discharge and that any load would be met by the grid…
-
Speaking to GE, a setting had been changed as part of a firmware update that caused me problems with my setup. The support desk were very helpful, and reverted it, which was then tested and found to b…
dbrb2 updated
7 months ago
-
**Original Bug Report no 565**
Single AC3 Inverter Economy 7 setup no export.
When low power mode is selected it operates correctly but is sending repeated commands to the Inverter as shown in the G…
-
Doesn't seem like I can get this to work at all. I have a 9.5kwh battery with a separate Gen1 inverter.
Logs as follows
2023-12-18 09:08:38,625 - startup - [CRITICAL] - HA MQTT Service has been…