-
Hi there,
I am trying to compile my own WLED binary for Wemos D1 mini with PIR-sensor support following [this](https://github.com/Aircoookie/WLED/wiki/Compiling-WLED) and [this](https://github.com/…
-
I have project with more than 50 arduino's (and will be more) connected to 7 Odroid XU and RaspBerry PI and I have big problem with auto connection to it. Every Arduino has own arduino_instance_id whi…
-
Hallo zusammen,
ist es möglich über einen Schalter der direkt an dem Board (z.B. D1mini) angeschlossen ist die LEDs an oder aus zu schalten, ohne dies über die WLAN Verbindung machen zu müssen?
A…
-
This may not be the correct place but I want to wire a AM312 Motion sensor to my esp32 how would I go about doing that with this project?
This is the sensor
https://www.amazon.com/Weewooday-Pyro…
-
how to add pir sensor HC-SR501
-
Hallo zusammen,
ich habe das Problem, bei meinem Monitor, dass er sich zwar abschaltet, aber nach ca 45 Sekunden wieder automatisch angeht.
Wenn ich das Skript ausführe steht immer Motion detected…
-
Hello, I wrote such a code, but the device does not appear on the homekit. Where am I doing a mistake? thanks in advance
Sorry bad english :(
i Json code:
{ "c":{ "l":13, "i":1 }, "a":[ {"0":{"r…
-
Hi!
I was wondering if I can use an AM312 instead of the HC-SR501 for motion detection.
And, the issue:
I am using the ESP32 with a DHT22 and a Motion Sensor. In the serial monitor, it keeps loop…
-
Hello,
Would it be possible to add a feature where a camera will record when prompted by an external trigger on a GPIO of the Pi, such as a PIR sensor.
Thanks Ben.
-
Hi,
Is there anyone who had success with HC-SR501 sensor?
I tried a few options but it doesn't work.
Thanks in advance,