-
I have one of your boards. At first it seemed fine. I didn't actually do anything I couldn't do already but it gave me the confidence to set the UPDI pin as reset. http://myiot.co.uk/attiny/
However…
-
Hi,
I have a T3216 that gets commands from an other T3216. Both are connected by PB2/PB3 (crossed).
If I switch off the power of one of them and turn the power back on the T3216 won't restart/re…
-
Despite your warnings on the menu, I still think it's a bad idea even providing an option in the UI that will brick users' devices. Also, the menu option ends up quite unsightly:
**UPDI Pin, READ D…
-
Arduino: 1.8.13 (Mac OS X), Board: "20-pin tinyAVR 0/1/2-series (ATtinyxxy6), No (saves space), ATtiny3216, 20 MHz Internal, 1.8V (5 MHz or less), Disabled/Disabled, EEPROM retained, Enabled (default …
-
I can't see why I'm getting this error in Linux Mint 20:
Arduino: 1.8.13 (Linux), Board: "ATtiny1614/1604/814/804/414/404/214/204, No (saves space), ATtiny1604, 20 MHz Internal, 1.8V (5 MHz or less…
pfoun updated
3 years ago
-
This use to work on the 1604 now it gives me a compile error
SoftwareSerial pixieSerial(-1, PIXIEPIN);
I have to declare a receive pin
SoftwareSerial pixieSerial(2 PIXIEPIN);
Ar…
-
Apologies for the dumbo question but after scouring the documentation I am none the wiser.
`The Optiboot serial bootloader is now supported on these parts, allowing them to be programmed via a seri…
-
Hi,
had a problem programming with mEDBG after updating from v2.1.3 to v2.2.6 (had another issue - closed - about that), so I'm now trying to use an MPLAB SNAP (PG164100) but still got problems.
f…
ffred updated
3 years ago
-
Can the programmer also used with DxCore (AVR-DA and AVR-DB) and MegaCoreX (AtMega4809...)?
-
Since Latest commit, i get an error, No target power.
If i move 5V from the updi header, to 5V on the arduino ISP header, it works, and flashes the attiny412 (need 2 tries, as it should atm)
Usi…