-
This seems to aaaalmost want to work with the K6.
This link implies that it should work:
https://www.mariolukas.de/better-software-for-k3-k5-and-k6-laser-engraver/
But all the comments are talki…
-
Pen on paper without any force applied seems to be an issue.
Apparently you can get very tiny lasers that can engrave.
http://www.instructables.com/id/Pocket-laser-engraver/
We like lasers and t…
-
In a perfect world.. I could take these designs and send the gcode to my cutter/engraver! The interior polygons could use 50% laser strength to merely score the material, and then the end of the cutti…
-
### Summary Description
Need the make under preference x y scale factor enable, not sure how the undimmed, need to enter a change to accuracy, it is off on my system need to change to 1.017 scale fac…
-
I just received the MKS DLC with the TFT24 LCD panel and the S109 drivers to use on a laser engraver but I can't get the stepper motors to move.
When I connect with a computer, I can access the RGBL …
-
Hello, my name is Matthew and I am very new to this GRBL software... I am a high school student interested in electrical/mechanical engineering and I am having a few problems setting up GRBL to run on…
-
I would like the ability to switch between my Huanyang VFD spindle using RS485 (with it's onw max and min spindle speed in my case 7800-24000) and my PWM laser engraver (speeds 0-255).
I don't mind…
-
So my homing cycle begins normally on my laser engraver, both x and y end switches are hit, both axis move back a little but then they hit the end switches again and instead of stopping, the motor kee…
-
Hi - I am running GRBL V1.1 on a Phoenix CNC controller which was built primarily to use with VFD milling. It has a smoothing capacitor to change the PWM signal so it is more like the analogue signal …
-
**Describe the bug**
Laser GRBL will try for a long time to connect and then give a generic "Error connecting to your machine" message. The com port shows up when the machine is plugged into the USB …