-
Hello i have a skr 1.4bturbo, with a bltouch installed. What pin can i use to a servo? I dont use neopixel pin, can i use it for put a servo?
![Capturar](https://user-images.githubusercontent.com/786…
-
I am wanting to add the analog joystick which is part of the bug-fix version you used. It is enablable in coonfiguration_adv.h but I am not sure what pins you left available if any that you could sugg…
-
I murdered my poor Skr v1.3 board with a loose wire my fault Doh. So i got a new Lpc1768 ic & other bits and fixed it. I was looking for a Bootloader i found this one
https://github.com/Smoothiewar…
-
To enable connecting microcontrollers in different ways than just serial-over-USB/BT/foo, some IP based transport would be nice, for use over WiFi/Ethernet.
Example microcontroller includes https://mb…
-
I would like to use Neopixels on my Printer.
By default Adafruit Neopixel is in lib_ignore in plattform.io for STM32F1 boards, because of compile errors regarding gpio_set, gpio_clear and time funk…
-
![image](https://user-images.githubusercontent.com/3938103/60772758-6e70d780-a12d-11e9-9fcd-26f94addc41e.png)
Already install driver from Virtual COM Port driver folder, still the same.
-
-
Hello, we bought a MKS MINI 12864 V2.0 to work with MKS SGEN_L V1.0, but we can not able to configure properly the marlinf 2 firmware to enable the LCD, could you give us a hand?
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
Can not compile the latest marlin. `platformio.ini` file is missing. If that is intentional, …
-
### Description of defect
LED is not blinking on some target boards.
Recently, following code has been added in this example code.
```
// Initialise the digital pin LED1 as an outpu…