-
Dear Betaflight dev team,
I got the GPS issue with 4.1.1
It fixed position very fast, but after several minutes, it down to 4 or 5 sats and hold at that for long time, and GPS rescue N/A warning, …
-
### Category
Other
### Hardware
T-Beam
### Firmware Version
2.1.18
### Description
In some cases, the Neo-6M GPS found on LILY TTGO T-Beam v1.1 units with SMA does not initialize correctly.
…
-
### Subject of the issue
Describe your issue here. If you reference a datasheet please specify which one and in which section (ie, the protocol manual, section 5.1.2). Additionally, screenshots are e…
-
Hello,
I'm using dma to read data from neo m8n gps module, it sends nmea sentences every 100 ms.
Since it's a lots of data roughly an uint8_t 400 element array.
So, I set up the dma and uart as fol…
-
Hi, I'm building a 4 inch quad with MatekH743 flight controller board, mRo GPS u-Blox Neo-M8N IST8308 as my GPS and magnetometer. I'm also using RFD 900x-US as my telemetry radio for remote communicat…
-
[24.08.2023 12:08:18] jasiu-rozowyczlowiek:
[24.08.2023 12:08:18] jasiu-rozowyczlowiek
-
Dear developers
I have tried your ubx lib with a NEO-M8N module but i couldn't make use of it. I have test my hardware with some other libraries like sparkfun and it worked, as I like to use this ubl…
-
Hello!
I try to update on version 2.1.0 from 2.0.0 and after it all work but GPS.
I use "BN-220 NEO-M8N GPS" and Omnibus F4 V3. Module configured to use NMEA protocol.
And after update every 3-5 s…
-
1. Stratux version: stratux-v1.6r1-eu028-32d5e58b.img
2. Stratux config:
SDR
- [ ] single
- [ ] dual
GPS
- [x] yes
- [ ] no
type: serial NEO M8N using…
-
how to flash ublox m8n??