-
The downloaded firmware zip file ‘m2k-fw-0.29.zip ‘ does not contain the needed BOOT and M2K files.
How can I find these missing files?
Note: the same applies to plutosdr-fw-0.35.zip.
Details:
…
-
There are reports that the Maia SDR firmware v0.1.0 doesn't work with a Pluto rev. C. After the firmware is flashed, the Linux kernel doesn't seem to boot completely.
On closer inspection of the di…
-
First of all thank you for taking on the burden of updating this! Really appreciated.
It would be super nice to have a way to execute a user script on startup, stored in the jffs2 partition. This w…
-
When using SigDigger with libiio 1.0 compat layer, changing the sample rate does not work. Values in the GUI are ignored. When I start the stream it uses the sample rate that is currently active on th…
-
Installed SDRAngel 7.3.1 and tested out USRP buy using 'uhd_usrp_probe'. That works fine. Plugins with SDRAngle show installed with version 7.3.1. There is not device option for a USRP radio availa…
-
I want to use a sample rate of 1.92 Mhz. Is it possible or do I need to configure the FPGA FIR decimator?
-
See post: https://ez.analog.com/adieducation/university-program/f/q-a/539472/plutosdr-v0-32-iio_reg-can-t-read-registers
I can repeat this on v0.32 firmware.
-Travis
-
```
/home/gnuradio/sparsdr/gr-sparsdr/examples/sparsdr_pluto_combined_block.py
Launching reconstruct: /home/gnuradio/.cargo/bin/sparsdr_reconstruct sparsdr_reconstruct --no-progress-bar --log-level …
-
Hi,
I recently purchased a PlutoSDR+. Is there a way to utilise this without downgrading the firmware?
I was also thinking this could be a good single device option as a cross linked repeater. Perha…
-
I use the Pluto SDR to generate DATV (Digital amateur tv) and found a limitation in the maximum sample rate I could use.
My setup is OBS -> FFmpeg -> GNURadio version 3.9.2.0-0 > Pluto
I used a s…