-
Hey Guys, I'm trying to remove the reset set on the Arduino board such that every input given at any point of time will have a smooth transition to the output.
Note
1) I've tried Shorting the pin o…
-
Rather than leave random comments in Slack i thought i'd post here.
6 cylinder: anything more than 2 squirts per cycle gives limited injector duty cycle.
Duty cycle also 'spikes' to the max numbe…
-
Hi Guys, first a presentation my name is luis and i'am from Seville SPAIN i build a speeduino 0.4 board and runs over renault clio sport 172, my engine have a aftermarket CAMS and have serious problem…
-
I think there might be a problem with the tooth logger in the October 2018 firmware. No matter what I try I can't seem to get it to generate any results. If I choose write to file, no file appears. I…
-
Summary here is that the stepper cranking table is not being read correctly, which causes huge stepper targets that the system can't meet due to int values being read from a byte based table.
See t…
-
I've been having trouble getting Speedy to recognize the basic distributor trigger.
If I turn the key and immediately crank the engine, it always detects the trigger.
If I turn the key on and …
-
HEY BROTHER , PLEASE HELP ME...
I HAVE A PROBLEM WITH CONNECT THE FIRMWARE TO ENTER IN THE (MEGASQUIRT SOFTWARE) THE (IDE) DETECT A PROBLEM , BUT NOT IS OF THAT YOU HAVE IN YOUR PAGE.
I HAVE A DCCD…
-
Hi im getting the error messages bellow while trying to upload/compile not sure what to do, a bit of help would be appreciated
corrections:146: error: 'PID' does not name a type
corrections.ino: In f…