-
## Issue Description
There is a discrepancy in the instructions for adjusting the current using the potentiometer between the following documents for the Infineon Stepper Motor Control Shield with …
-
### What happened
I have hybrid hardware, and it was initially enabled, but due to doing some debugging I set it to CoreXY mode.
Rather than changing my wiring, instead when I changed to corexy, I…
evilC updated
2 weeks ago
-
I realize that stepper motor is in the todo list, but I stll want to lift the posibilty to use RC-servos to controll valves.
-
After following the guide, I foolishly looked at the model number on the Y-Axis Stepper and determined it to be the 1.2a model. I also verified that in the printer.cfg they were set to 1.2.
Howeve…
-
Hello everybody.
If you want to use a 3MS or BoxTurtle mmu, then there is a need for a board with a sufficient number of stepper motor drivers. Thus: how many colors are there - so many stepper motor…
-
## Feature request
### Timeline:
### Stepper
Horizontal:
**
## TWO ERRORS
component tabs gets error when accessed from page …
-
Hello, thank you for the the awesome work, is it possible to include support to all the defined steppers no matter what the are called in the printer.cfg, including [manual_stepper]'s