-
For nets that are 1 pore thick the following line breaks as the points are essentially 1D and need to be at least 2D
hull_in = ConvexHull(points=inlets[:, Nin])
The bug was found when calculating …
-
Hello PMEAL team . In InvasionPercolation algorithm "find_clusters2" method is called. However,
"GenericNetwork" doesn't have included its. Therefore, when I run invasion percolation the follows mes…
-
We do allow this in some cases, but I think we should NOT. This would make the topotools even more general for future transfer to a separate graph package.
-
When using 'calc_eff_diffusivity()' method in Bravais(FCC) network, exception raised.
: _Exception: Detected inlet pores are not coplanar_
Because of this issue, domain area and domain length need…
-
I've been trying to compare some tests between versions on a voronoi network. I use check_network_health to identify disconnected clusters and the like which can result from very small throats being c…
-
HI,
I've been using OpenPNM for my research and just updated to V2.0. However, I got some issues for adding boundary pores in Bravais 'fcc' network and VoronoiFiber material and defining physics in t…
-
When using `find_cluster` method, Spyder complains that `scipy.sparse` has no attribute `csgraph`, which probably stems from Python's `import` mechanism that doesn't automatically import modules deepe…
-
* Move QuickUnion to topotools,
* re-implement ``find_clusters`` using it
* Adjust Drainage and OP to use ``find_clusters``
-
When creating a Network we ask for the lattice spacing, but the desired value is highly dependent on the Geometry models/values used. It might be handy to have a method that automatically adjusts the…
-
If I have a triclinic simulation box, using the mergemols() command gets rid of this information. writelammpsdata() then prints the box incorrectly.
It's an easy fix to topoutils.tcl if both mols h…