-
# HW-655 WiFi RELAY
Probably the low end of esp relay possible...
![HW655](https://hackster.imgix.net/uploads/attachments/322387/esp8266_11213_iuLdaYCO6s.jpg?auto=compress%2Cformat&w=900&h=675&fit=m…
-
Hi,
Is it difficult to add estop support to this driver? And what features does this add?
Thanks!
-
I thought that 3.3v output PIN cab be used to drive some other sensor or something like that,but it doesn't have enough juice to drive sensors.
So I put the pin to good use by connecting to GPIO of E…
-
I had setup helper and GUI mods working perfectly on V2.93 but I added the Orion XS and wanted to update to newer version. Now I am unable to install setup helper. I get the message "package manager n…
-
### Problem description
I'm using the Hive devices SLR2B (Boiler relay/controller) and SLT3b (Thermostat/wall unit) by Computime which are the Hive zigbee units.
I have paired them up with informati…
-
**Setup:**
- TerrariumPI version: 4.12.0
- Install: Docker
- Raspberry PI: 3B
- OS: Bookworm
After upgrading the OS to Bookworm and stepping up from 4.11. to 4.12.0, I can't start the conta…
-
**Describe the bug**
Controller will disable the relay provinding power to inverter even when no rules have been triggered. This usually happens when battery is at/or close to 95% - 100%, there is no…
DrBit updated
7 months ago
-
Hello,
I am having an issue with my Sequent stacks or Hats.
https://sequentmicrosystems.com/collections/all-io-cards/products/building-automation-8-layer-stackable-hat-v4-for-raspberry-pi
I …
-
Hi,
For a future version, it would be better if you could swap the Vcc (3.3V) and GND on the pins row:
```
[... | 15 | 14 | Gnd | Gnd ]
[... | 04 | 02 | 3.3V| 3.3V]
```
to this instead
```
…
-
I the pin image you labeled VIN 5V. This does not work by default. Is there a way to activate it?