-
I've noticed that baro drift negatively over time so from 0 it goes even to -6 m over one hour log, does this happens only on sensor or also on others?
-
The calculations for calibrated pressure for the BMP180 produce a value that is about 1.5 times what it should be.
-
Powering the board causes an I2C error with the current version 1.3 and the baro is not activated in the hardware bar. After rebooting the board (switching to cli and back) the baro is detected and wo…
-
I stumbled over a coarse resolution of the `BMP180` sensor connected to an `STM32F103C8T6` at `I2cMaster1`. When reading exactly two bytes the first byte is not acknowledged by the master so that the …
-
Hi,
have you planned supporting [OrangePi](http://www.orangepi.org/) platform? I'm using happily DHT11's and BMP180 on and old RPi revision; I tried installing these python libraries on OrangePi... of…
-
-
Hello. help me please
BMP180 sensor outputs temp +6 C of natural(it 30, but right=24)
-
Hi,
I am getting strange behaviour from Zabbuino. It seems to not responding correctly to Zabbix after some time (it is different each time).
Zabbix item gives me this:
> Received value [30??zabbuin…
Hy3n4 updated
8 years ago
-
Hi
I upload code to an arduino. my code has problems because L3G library has problem .
after I delet L3G from code the code is compiled ,but when I upload it on my arduino board and test it with proce…
-
As we are adding more devices, it's getting hard to find them. For instance I organized the seedstudio devices under grove which was probably a mistake.
My suggestion is to use the manufacturer name …