-
![](http://i.imgur.com/S0Ekmao.png)
The gui appears very different from what is intended. Many of the widgets were not shown until they were moused over. Mousing over is the only reliable way to in…
-
I wanted your opinion on this.
Why is this kext mapping to 0c0c -> oc0d?
My HDAU device is natively recognized, so no opportunity to test this, but several people I've had try it have failed. So ma…
-
So, I had a project (electronics enclosure) for my ShapeOko, and on one test run with a new material I noticed a very curious positive Z drift. What threw me is that I've been using the same electroni…
-
In one of my first tests I wanted to carve a name plate. I used inkscape and exported the paths with the gcodetools. I moved the bit to the beginning of the piece close to x125+,y20+,z-60 and send a g…
-
please comment on these ideas:
### invert pulloff logic
when we hit a homing switch, we reset coords to pull_off first and then move to zero:
- zero isn't at the exact same spot where the switches tr…
-
Bonjour,
L'exercice ne se valide pas, même en obtenant la figure demandée. M.Festor l'a trouvé juste. Les objectifs ne correspondent pas vraiment à des flocons de Koch, le problème vient peut être de…
-
Running $G dumps the following:
```
[G0 G54 G17 G21 G90 G94 M0 M5 M9 T0 F750.000]
```
Let's say I want to run the command
```
G1 F300.0 Y50.0
```
In v1.0.5, if the override speed was set to 50%, …
-
I have been trying to cut a 2d part with tgfx and two times in a row, the machine has stopped running midway through, with the following information on the terminal:
[+]User has entered text mode. T…
-
strtod() will parse "E" as scientific notation, but "E" is a word in G-Code (and G-Code does not use scientific notation at all).
strtod() will parse "0X" as a base-16 number, possibly spelling disast…