-
1. Stratux version: v1.6r1
2. Stratux config: dual SDR, GPS yes adafruit MTK3339 , AHRS no, vehicle 12v-5V USB power.
3. EFB app and version Ozrunways 10.3.7 . EFB platform ( iOS 14.8.1). EFB hardwa…
-
Hi Jack,
I have a project that I set aside, and am just getting back to. Amplifier controller, but it incorporates a fan control, and I was looking at your project for reference. I saw that on your…
-
As we have talked about on email. I have now tried a brand new Simarine Unit, and a new RPI with clean installed Open Plotter. It will not communicate. Log looks like this:
Aug 19 20:31:27 2024-08-…
-
Sleep was implemented after sending measurements through MQTT to save battery (measurements every 5min with sleep in between). This also allows to fully charge the NCR18650B (up to 4.12V) with the sol…
-
create/ verify layout component by lead spacing, hole or pad, component height, general size for:
- [ ] 100 resistors
- [ ] 1k resistors
- [ ] 2k resistors
- [ ] 22pf capacitors
- [ ] 22uf capaci…
-
Olá, parabéns pela excelente biblioteca.
As células que sofrem merge não estão respeitando a borda ALL, testei aplicando borda antes e depois de fazer merge, mas o arquivo só fica com borda na prim…
-
Currently I have a Pi4 w/ FTDI cable connected to the Elite 64-W's COM port. With this I'm able to connect to Wintex (PlayOnLinux) in PC-Com mode. I'd really like to use pialarm with my Elite 64.
H…
-
Hey, I really like the design! How is Power Delivery supposed to happen in the V1.3? Only through the Barrel Jack? I would like to power with 16850s or a LiPo Pack, which usually all don't get to the …
-
Good Morning,
I am planing to use one of the RGB Ports for a Chamber Fan on my Voron 2.4 which i am building currently.
Because i already had all 3 FAN Ports in use, i think over to use a RGB Port…
-
```
What steps will reproduce the problem?
1. Brancher l'arduino sur du 12v
2. Appuyer sur un interrupteur de test
3. la porte ne s'ouvre pas automatiquement
```
Original issue reported on code.go…