-
The pin assignment for PWM0 and PWM1 are reversed on the board. PWM0 (gpio16) belongs to fan1 and PWM1 (gpio17) belongs to fan0.
This should be adjusted in the documentation in the SB2040 cabling sec…
-
Hi,
i am trying to make fresh smoothieware work with TFT35 v2. The provided binaries here work - the display connects to board.
However if I use fresh binary from Smoothieware's github, everything w…
-
Configuring sensorless homing on a trident with M8P + CM1 + SB2209.
During the setup of the sensorless homing I go through the recommended process to start the test by setting the sensitivity to ma…
-
It would be good to know the max current you can draw from each port and especially the onboard voltages
For example:
1. Maximum current that can be drawn from all combined 12V ports that are fed fr…
-
My SKR 1.3 was working fine when the thermistor wire accidentally touched against aluminum block (I didn't see the wire was out of the plastic tube) and T0 shows 40ºC, even if nothing connected to the…
-
Hello everyone.
Can someone from BTT explain this, please?
And also what changes you did to the firmware, since the new versions on GITHUB are dated from 8 days ago...
#
# BigTree SKR Mini V1.…
-
The core of the ESP8266 ESP-07S module in the slot BTT SKR2 VB boards - the printer is not recognized in the WIFI network.
What should i do? Please provide information step by step to change this.
M…
qulet updated
2 years ago
-
I have the problem that some of the specified pins are already reserved for CAN. This means that I cannot use the ADXL cs_pin: EBBCan:PB12. Klipper gives error, is reserved for CAN. The E3EZ uses PB12…
-
I ordered board with drivers from btt shop configured fw and uploaded it to board configured jumpers inserted drivers and started it. Board ran for 15 sec and shut down i saw leds turn off ater i remo…
-