-
I use a bluetooth module connected to UART1 on my BFFC3 board running at 115200 baud. The +5 supply to the Bluetooth module runs through a simple switch that allows me to power the bluetooth module ju…
-
When giving full throttle I lose control of the craft.
Betaflight 3.1.7 spracing f3 and
-
Currently the list of choices for gyro_lpf include "OFF" and "EXPERIMENTAL". In the code, the list of choices is intended to let the user set the cut point of the hardware LPF in the gyro; it then se…
-
Hi
is it possible to get the latest version of inav on a motolab board? I only able to flash version 1.3.
might be related to [Issue 1757](https://github.com/iNavFlight/inav/issues/1757)
-
Hello,
I am using an Omnibus F4 (non pro) purchased from RTFQuads... in a small GPS camera ship build. I am using an Futaba Sbus receiver (R7008SB) connected to UART 6 marked PPM/SBUS and SBUS is…
-
With the sensor connected to the i2c bus on the device it will register 2 i2c errors on boot, but will not see the barometer. I have verified the barometer works fine with an arduino.
I'm assuming …
-
The Cleanflight 2.x code now is exactly the same as Betaflight 3.1.7, so it must act exactly as the BETAFLIGHT (or BETAFLIGHT31) definition.
The easier solution is to add a `#define CLEANFLIGHT2` t…
-
# A - Description
Hello, I just get from banggood F3 Flight Controller Deluxe 10 DOF - it is similar to spracing f3 deluxe and it includes barometer and magnetometer. After upgrade to newest version …
-
Hello,
I have been testing inav_1.7.1_OMNIBUSF4V3-1 obtained [Here](https://github.com/iNavFlight/inav/pull/1779) LED strip control does not appear to be working.. I have tested the same board…
-
This didn't happen about a month ago -- looks like several references to the "BRUSHED_MOTORS" define were removed rather recently.
It also seems that ESC/Motor features aren't sticking when set in…