-
-
hi biqu/bigtreetech and dev-users hereoff
i have a hermitcrab v1 that connects to a btt pi2 through the BTT RPI-CAN HAT V1.0 CAN module.
but i can't get a connection trough.
i tryed it because …
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
btt skr 1.4 turbo, tmc 2209 drivers
### Bug Timeline
_No response_
### Expected behavior
…
-
Hi,
i got a M3 Screw style type K thermocouple and a MAX 31865, but got no clue how to wire this correctly to the SKR-3.
The manual only states that the integrated PT1000 circuit has a much lower re…
-
https://raspi.debian.net/tested-images/
-
When the print starts, the temps climb properly. Once the print is finished, the temp indicators stay at print temperatures event though the bed and extruder are cooling down. After a print, even wh…
-
I have just received the TFT35 SPI V1.2 and IO2CAN and want to use them with a Raspberry Pi 4. There is little and I mean almost none documentation about this subject. Everybody connects this screen …
-
### Did you test the latest `bugfix-2.0.x` code?
No, but I will test it now!
### Bug Description
Stepper motors are noisy/vibrate at low, medium and high speeds (30mm/s, 60mm/s, 80mm/s, 120mm…
-
The rabbit logo on file [a]_BTT_MMB_Support_Arm_Endcap.stl is an overhanging surface of 0.25mm off of the build plate, Orca/Prusa slicers will not support it. This causes print failures.
There is thi…
-
Hi,
Thanks a lot for doing that, I unfortunately overwritten the source bootloader then I found your project (after BTT refused to share their bootloader).
Unfortunately it only made it possible…