-
Hello, this is a rather minor issue, but I am not sure why it is happening. I initially had Cleanflight and used a desktop shortcut to open. This worked fine, but now all the shortcut does is open a b…
-
I find two same code in one function,why?
https://github.com/cleanflight/cleanflight/blob/master/src/main/scheduler/scheduler.c#L212
sorry,I can not understand "taskId == TASK_SELF".Why we need to…
-
Hello everyone！ I have read some of the content on cleanflight's official website and gitbub. But I don't know how to learn it in a planned way.
-
Hi guys,
I noticed that the motors are constantly speeding up while the quadcopter (QAV540 frame) is staying on the ground. The result is that the quadcopter tries to take off at min throttle after…
-
# 1. ARE YOU REQUESTING SUPPORT?
-- YES --
# 2. If you answered YES to the above question go here instead:
https://www.rcgroups.com/forums/showthread.php?2249574-Cleanflight-firmware-for-STM3…
-
I think ROSFlight sounds like a terrific solution to an easy to get into flight control system! I have gotten hold of a Naze32 Rev 6. One of the changes is that Rev 6. has a upgraded MPU 6500 vs 6050 …
-
# A - GPS stopped working during an update to Cleanflight 2.0.2 (from Cleanflight 1.x).
# B -
1. My receiver is PPM mode, so I connected channel 7 TX to RX of GPS, and channel 8 RX to TX of GPS. …
-
Betaflight 2.9 seems to think there is no magnetometer on the SPRacing Evo.
Not a hardware issue, the mag is detected by switching over to cleanflight.
-
Hi guys,
I've flashed the betaflight SPRACINGF3EVO 3.1.7 10-04-2017 13:36 on an Eachine v-tail 210 and the LED strips are not working as expected: four of the LEDs are lighting white (and sometimes t…
-
Hello,
This is a feature request.
I'm interested in having the ability to see an indicator that the craft is in fail safe.
It would basically be the same as the arm/disarm status but would actuall…