-
Somehow the speed is very slow when using the FTDI driver (D2XX) with the MSVC build. I have set the latency timer for the serial port to 1s in this case but I think that does not matter here.
```
…
mcuee updated
7 months ago
-
I sucessful use FF with an 26-pin header Gotek Floppy and use it in my Tektronix TDS3000 series (TDS3012B) Oscilloscope. The PB and the LEDs are at the same pins. I have to remove the resistors RA & R…
-
Hi, I tried to upload the latest source to WARBL2. I followed all the steps using Arduino 2.3.2. I did not know which usb ids to use, because those given in the installation guide do not match those r…
-
This repo is my exposure of my attempt to keep my privacy faced with Chinese hardware with no published privacy policy....
If you have the same or similar camera, and are interested in contributing, …
-
### Distribution
Ubuntu 22.04
### Architecture
amd64
### Kernel version
6.5.0-35
### IMSProg version
commit 0573530
### Bug description
cmake ask sudo passwrd
```
~/build/IMSProg/IMSProg/IM…
-
Hi,
Apologies if this is not the right place but someone on discord advised me to post on the GitHub and I'm not sure if this qualifies as an issue or a feature request. I couldn't find a feature req…
-
Any compatibility with the DS213?
http://www.miniware.com.cn/product/ds213-mini-oscilloscope/
Other sketchy sources (ebay, banggood.com, etc.) say this has 15MHz Analog Bandwidth.
From main w…
-
Can my flashcard, "R4i Gold 3DS" be compatible with ntrboot_flasher?
This flashcard can be updated if you put a .nds file from the [official page](http://www.r4igold.cc/3ds_main.asp) in the SD and…
-
some back story, when the AVR DB-Series was just released i made a simple arduino-like board for the AVR128DB48, with onboard FT232RL and the arduino reset circuit with the ~DTR pin.
i also put optib…
-
http://3dprintboard.com/showthread.php?15326-Qidi-Tech-1-Replicator-2-clone&p=94492&viewfull=1#post94492
Please refer to the link above, and read through a few pages of posts. I have been suffering f…