-
Hi there,
I'm currently using OpenOCD on a Raspberry Pi to program an STM32L0. I've written a basic Python wrapper around OpenOCD as a quick fix. I'm wondering if there are any examples or documen…
-
I cannot figure out which pins to set for the reset script.
spi and i2c are enabled.
tyro@rpiz:~/LR1302_loraWAN/LR1302_HAL/sx1302_hal/packet_forwarder $ ./reset_lgw.sh start
CoreCell reset thro…
-
Any chance of supporting a Mic? there's a few cheap boards that would work with the GPIO ports on the Pi
-
I started using this and found what I think isn't normal behavior:
The piezo beeps continuosly every 6 or 7 seconds, doing a different tone each time. I believe I discovered this is because the UPS…
-
I'm trying to get a BG96 module running with a RPi 0 2W via a UART. This is their Mini PCIe module, mounted on the Sixfab Base Hat. After fiddling with the IEx console output settings, I am able to qu…
-
I have Jasper setup and mostly working on my RPi3. The problem I'm encountering is that when I start Jasper ($ python jasper.py) it launches and says "How can I be of service, Adam?" I then say "Jas…
-
## Bug report
### Describe the bug
Here is a clear and concise description of what the problem is:
Lower-resolution videos suffer from lag on Raspberry Pi, with the video progressively getting de…
-
I flashed the image `openwrt-bcm27xx-bcm2711-rpi-4-ext4-with_oled096_factory.img.gz` with Etcher, and booted the Pi. In OpenWRT, I can't see the PORT1 interface (the WAN port, connected via the RTL811…
-
Setup ends with a `sudo: unable to resolve host bthidhub: Name or service not known ... FATAL ERROR: Remote side unexpectedly closed network connection` message. See the log below.
I tried it on bo…
-
Hello,
### Brief description:
with motioneye dev I have the problem that zobie processes remain in the system. From about 700 zobies the memory runs full and the system stops.
### Detailed desc…