-
I have been working on getting smartport working on F4 targets.
Because the F4 does not natively support UART inverting, I used the taulabs inverting circuit on UART3 in an attempt to get some sor…
-
Hi guys,
I've flashed the betaflight SPRACINGF3EVO 3.1.7 10-04-2017 13:36 on an Eachine v-tail 210 and the LED strips are not working as expected: four of the LEDs are lighting white (and sometimes t…
-
I am using the 0.5 version of Triflight on my CC3D. By the way, I checkedout the version 0.5 tag and used this command make TARGET=CC3D
So after flashing, cycled the power and connected the battery, …
-
I think that might me important. I was setting up a quad for a friend, so I flashed latest inav and applied 5'' preset. And than I wanted to flash escs to newest blheli. And flashing for all escs fail…
-
request for ibus telemetry support and/or transfer of code from https://github.com/unitware/cleanflight/tree/ibus-telemetry to betaflight 3.xx
original issue from cleanflight https://github.com/clean…
-
# A - GPS stopped working during an update to Cleanflight 2.0.2 (from Cleanflight 1.x).
# B -
1. My receiver is PPM mode, so I connected channel 7 TX to RX of GPS, and channel 8 RX to TX of GPS. …
-
I'm using an omnibus f4 v3 from ready to fly quads I updated the firmware to 3.2.0 from 3.1.7 to use dshot 1200, everything works the same as it did accept the voltage monitoring I just have this and …
-
# 3. If you answered NO to the first question. Delete everything above this line, read the guidelines (see link above this form) and continue.
# A - Description
-- Tried to Load firmware (onlin…
-
Quite a while ago (before going to airplanes) we removed `emf_avoidance` option. But F1 and F3 chips run at 72MHz, 6-th harmonic of which is 432MHz. This may cause issues with LRS operating in that ba…
-
With the laptop in the field on a sunny day i find it very hard to see the lines. Thicker lines would help.
hydra updated
7 years ago