-
when i set my motors to always be on with the command $1=255 the motors makes noise is there anyway to remove the noise?
also i have the drivers DRV8825 what would be the correct setting for $0 = 1…
Radiu updated
7 years ago
-
I have a gcode program for my laser engraver that uses X movement a lot but very little Y movement (raster engraving), which makes Y stepper become very hot when in holding torque mode. How to tell gr…
-
-
Over the last few weeks I have been working with a user in NC who is doing a retrofit using a SainSmart 2in1 control board.
Last week (March 24, Friday) he reported a failure shown in the attached…
-
I have just finished setting up a 2 axis cnc/printer for a school project of mine. I am using an arduino and a generic v2 cnc shield. I am not really sure what drivers it uses and may upgrade them lat…
-
Dear all, i'm a newbie in bcnc. Some weeks ago I've started building a pcb milling maschine. I use the following components/projects:
- PCB cyclone (https://github.com/CarlosGS/Cyclone-PCB-Factory)…
-
We need a 12V, ca. 1.2A power supply for the Stepcraft. The milling shield has screw terminals for wiring.
-
this two pins are not with PinMode declared to Output
pinStepperDir = 16; //Direction pin for DRV8825 driver
pinStepperStep = 17; //Step pin for DRV8825 driver
-
Hi, I'm from Spain and I don't speak English well, I'm sorry fot that .
I have a problem with the measurements of the probes, the value is not correct, instead of being close to 0 are far above, in t…
-
In this ticket I want to share you a tips to reduce the noise of the sigma and an engancement request.
About the request, is it possible to activate the heated head fan only when the nozzle is heatin…