-
Hello!
**Versions**
- STM32CubeIDE 1.10.1
- STM32Cube MCU Package for STM32H7 Series 1.10.0
**Problem**
I tried to compile the STM32H743_Nucleo_ETH example but it causes an warning duri…
-
### Answers checklist.
- [X] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there.
- [X] I have up…
KaeLL updated
5 months ago
-
My setup:
ESP-WROOM-32
ILI9341
XPT2046
16GB SDHC
Everything is wired up correctly, as you can see below, but something is wrong with the image... Application somehow thinks this is not a 320x240 …
-
I have few DIY-IoT esp32-based devices connected to this router. I see that they are getting a new IP each hour. Is it configurable somehow? Thanks in advance.
-
Hi,
Could someone please confirm that the MCBSTM32F400 solution should compile with GCC?
I'm working on adding network support for the Discovery board and was using the MCBSTM32F400 for validation.
I…
-
Pimoroni have announced a new board with an RP2350 and WiFi. I have two on order.
https://shop.pimoroni.com/products/pimoroni-pico-plus-2-w?variant=42182811942995
So far the only software suppor…
-
### Answers checklist.
- [X] I have read the [Rainmaker documentation](https://rainmaker.espressif.com/docs/get-started.html) and the issue is not addressed there.
- [X] I have updated my IDF branch …
-
I don't know if my configuration is wrong or if the plugin itself isn't working correctly
-
If the following conditions are true...
- module A depends on module B
- module B depends on module C
- module B is linked by module A
- module C is not present in module B's yotta modules
Then the f…
-
ipv6 address is not assigned to right interface on BorderRouter
reproduce steps:
1. setup topology using happy script standalone/thread_wifi_on_tap_ap_service.sh
2. run mock-weave-bg on BorderRoute…