-
Hello.
I want to know that Which version of Carla simulator to use in the motion planner repo.
Which article is referenced by the collision detection method?
-
hello mark,
i am having difficulties in connecting a pixhawk through a nucleo moab board. how do i make connection between the two? i am using a brushless dc motor, is brushless ESCs necessary? or ca…
-
As title, lets prepare a short soa on control based methods applied to problems similar to the gap_crossing task. Put here references, for each reference you also write a short summary on the method.
-
Hi Team,
We have more than 1000 acres of agricultural land. We take images from the drone and the total size of images generated is approx 90GB. The number of images is more than 10000.
The images…
-
While investigating the Prusa inconsistent extrusion issue
https://github.com/prusa3d/Prusa-Firmware/issues/602
which I believe you're already aware of (though that thread has gotten out of hand)
I…
-
Text for the About Panel and other areas. Also located here in Static Text_MASTER
About Panel
The Utah Geologic Hazards Database contains post-2008 UGS geologic hazard map data and data from oth…
-
I am opening this "issue" as a way to collect ideas and opinions/advice on the ongoing Linear Advance implementation (before I actually start coding it!) that should not only compensate the usual trap…
-
Hi,
I'm using the FFTW library to implement one-dimensional FFT in a bolt of the Apache Storm. When I run it in the single-thread mode, everything works fine. However, if I tried to run it in the …
ghost updated
4 years ago
-
The document says that HTN is supported after 3.8.1, but syntax error is reported
(defdomain UnmannedCombatVehicle
(
(:operator ( !operator-move ?parameter-agent ?parameter-from ?parameter-to )
…
-
Is anybody else seeing layer shifts on BugFix 2.0.0 ? I'm seeing one or two of them on long prints. I'm seeing them on the X-Axis (and mostly in the negative X direction).
I'm running an IDEX m…