-
I want some help me with same setup attach him config files there ... because i move these drivers from E3 DIP to SKR 1.3 with same Marlin , changed only address for drivers on this board , but…
-
I'm not sure if this is a bug or operator error.
I have tried many combinations of setting up the thermocouple for the E3D V6 hotend on the Bigtreeteck MKR Pro board. I am using the thermocouple ampl…
-
so i have seen that you have added onboard EEPROM, but i did't find anywhere in firmware use of it!
Please change it!
-
After having the skr mini v3 for awhile i decided to add a BL touch. Installed that and the firmware from github but i cannot get the ender 3 3d printer to auto home the z axis nor auto level the bed.…
-
Setting nozzle and bed heating temperature does not work for PS1. I am on latest firmware 01.06.01.00 and latest panda touch firmware.
-
After booting up with new firmware for the dual IDEX Upgrade kit with dual Z axis I get the error:
All Low
and
Failed to enable Bed Leveling
Homing does not work
![805C9570-094F-4648-ABF5-0ED…
-
Hi, I tried to install this sensor, but it is not working, as you guys said! please help
this is what I get :
02:32:10
$ G28
02:32:19
// Real time leveling height:0.000000
02:32:20
!!…
-
Thank you very match for you work, but the interface of the device is very inconvenient even compared to the 12864 from Marlin. This needs to be finalized.
If you wish, I can prepare sketches for the…
-
I was able to compile and load the latest firmware file from this repo, (red LED flashes then stops, file on card changes from .bin to .cur). However, the LCD screen remained blank and the board is no…
-
While I can try both and see what works, I though it might also be an idea to have the documentation tell me.
should it be
#define POWER_LOSS_PULL pulldown
OR
#define POWER_LOSS_PULL pullup…