-
I'm running NAZE 2.9.1 firmware. I powered my quad with the arm switch in the active position. No problem. The motors did not spin. I had to toggle the arm switch on the transmitter to get the mot…
-
ping @staticfloat
I am having trouble to install ProfileView. I fail with building homebrew. the below output comes after `Pkg.update()` (where this error also occurs), and after removing Homebrew, G…
-
Hey Folks,
The problem does not happen every time I way hard, but after about a minute of trying to invoke the problem it will happen. It looks like when I yaw left or right, one of the motors loses…
-
Hi All,
I was initially running 2.9 then 3.0 r6 then r12. Since r12 I have had to flipouts when the quad has been armed. Motor 3(rear left) is the cause. It does not spin. This has happened on two se…
-
Good evening.
Thanks for your efforts in making the iNavFlight.
I have a [10DOF SpRacing F3 Clone from Banggood with internal compass](http://www.banggood.com/Upgrade-NAZE32-F3-Flight-Controller-Ac…
-
Hello, i am on Version: INAV/SPRACINGF3 1.2.0 Aug 18 2016 / 13:48:20 (5b8b978)
when i add a range to NAV POSHOLD or NAV RTH, then i can´t arm the copter.
I can add ranges to other modes without a Pro…
-
Hello, I do not know if this is the right place
No longer connected to the flight controller after a save with the
LED_STRIP feature in CLI or with the button in the configurator.
Also can no longer …
-
Target: PIKOBLX
Betaflight version: 3.0.0 RC12
Go to CLI:
set telemetry_inversion = OFF
save
Go back to CLI
get telemetry_inversion shows ON
Dump:
# version
# BetaFlight/PIKOBLX 3.0.0 Aug 27 20…
-
Hi Boris, I tried betaflight 3.0 on my Sparky 2 board and I experienced some weirdess:
1) When I set an arm mode, the position marker moves as if it would arm but the bit on the left in configurator d…
-
When I enable accelerometer via "set acc_hardware=0" I can arm again.
Here is my dump:
# version
# BetaFlight/NAZE 2.2.0 Dec 31 2015 / 00:50:34 (560bd74)
# dump master
# mixer
mixer CUSTOM
mmix rese…