-
Add a amperage input to the Electrical Source item gui to give the ability to set the max Amperage a creative Electrical Source can provide
this would be very useful for testing how breakers react …
-
P'tit problème de synchro de mise à jour de la géométrie dans la synthèse lors d'une modification de la géométrie d'un relevé sous occtax.
Lors de la modif sous occtax seuls les champs `the_geom_432…
-
I notice that there are two files `modules/am2320.c` and `driver/NmraDcc.c` that are licensed under the GPL. This is not compatible with the MIT license that the rest of the nodemcu firmware is licens…
-
When this happens the robot will not start up and a restart is needed.
As I hear from @JosjaG this problem occurs for multiple teams and Toyota should probably be informed of the problem.
The actu…
-
I noticed on [OMs OpenIPSL test](https://libraries.openmodelica.org/branches/master/OpenIPSL/OpenIPSL.html) that [Examples/.../ESST4B](https://github.com/OpenIPSL/OpenIPSL/blob/master/OpenIPSL/Example…
-
I have a TH10 with an official SI7021 sensor connected. It works fine through ewlink with original Sonoff FW 2.0.4. I dont get any sensor appearing when flashing Tasmota 5.5.2.
I can see that other…
-
I just grabbed and built (after a `make clean`) the latest dev version. When I run it, our USB3 open-ephys board is detected, but the RHD2164 headstage connected to it (Port A) isn't detected when I a…
-
I would like to contribute the following. However:
1) I'm new to Github
2) I have no idea where it would go in SciSharp Tensorflow.
3) I'm not part of the project so I have no access anyway.
Thi…
-
Hi,
I tried to launch FMPy on a Raspberry Pi model b. The installation was successful and I managed to load the 32bit LINUX FMU (Model Exchange). I can also display the model information. As soon as …
-
**Describe the solution you'd like**
- Recognize when the glove is plugged into the charger.
- Select between 4 notes automatically without assistance from the MCU. This will likely use a 555 timer,…