-
I'm getting "Homing failed due to printer shutdown." or "Unable to write tmc spi 'stepper_x' register GCONF" when trying to home custom Vorom 2.4. I've checked motor wiring and all checks out
Runni…
-
This repo is more than a year out of date, and does not reflect what is currently hosted on Maven. This makes it difficult to find reference source code when issues arise.
-
This helps to abstract the address on the RIO for the various inputs / outputs. It allows the commands to be fairly abstract and updates to them can occur in one master map.
-
Find a way to set
`internal: true`
in sensor if it's already on inputs.
The writable parameter could be the trick.
in sensors_LANG.yaml
the parameter `internal: true` must be add
```
- p…
-
Communication timeout during homing probe
-
I just had to uninstall and reinstall Klipper to fix a "dirty" issue. I installed Klipper with KIAUH then went through the install steps for BDSensor.
~/Bed_Distance_sensor/klipper/install_BDsenso…
-
This is only a feature request.
I like to see, that TL deal with more than 9 channels, if the Tx/Rx can do that.
My Graupner perhaps can deal with 12 channels.
An other guy implement Graupner SUMD an…
-
Scenario: When the printer is in a ready state, I used [MMU_SYNC_GEAR_MOTOR] command to extrude some filaments, and then I started printing normally, When the extruder was loaded the filament to the t…
-
Hello dear friend. I tried to use your creation, but it wasn't successful. Before that, I tried a similar project and it was launched successfully. Here I encountered the problem that the dashboard do…
-
To all slLIN users,
the project mainline/upstream is hard to be found which results in annoyance, redundant solving of the already solved issues and other time waste. If there should be chance for …
ppisa updated
3 years ago