-
**Describe the bug**
Cannot perform any data manipulation on MIRI MRS data using specutils. The working theory is because WCS-TAB is not fully supported somewhere in the stack, but we are…
-
This may be solved when we stop using spectral_cube and start using specutils to load cubes.
WARNING: No spectral axis found; header may be non-compliant. [spectral_cube.cube_utils]
WARNING:astrop…
-
I tried to estimate the spml parameters of a real scene based on the `colab demo`, and the gradient got stuck after 3 to 5 iterations. Camera parameters are estimated based on [calibration app](https:…
-
I'm hitting this issue on both Perlmutter and Crusher when running without gasnet:
```[0 - 7f1c263d7700] 0.696958 {6}{ib_alloc}: impossible: op=0/0x7f1c108403a0 mem=1a00000000000001 needed=26856…
-
I usually don't use brim, but found myself wanting it for a few prints with lots of small pieces attached to the bed only by small surfaces. However brim is damaging to remove, and I want surface qual…
-
What is your question ?
Not sure what is going on here, but this just started. When I try to upload a gcode to my printer from Simplify 3D the printer firmware reset and disconnects from the compute…
-
(base) user@user:~/dhwani/MutSig2CV$ bin/MutSig2CV /home/user/dhwani/funcotator/passed/combined_passed.maf /home/user/dhwani/funcotator/passed/out_results ./reference/params_file.txt
Warning: lates…
-
Separate settings for:
- above raft speed (the first layer that is printed on the raft top layer)
- raft model z-distance (or separation distance) currently this is fixed at 0.3mm and can only be ad…
-
Hi
I have Ultimaker 3 and experiencing issues with the software.
I fill 100% and still see that there are empty spaces inside the walls.
The only work around for now is to set "wall line count" p…
-
Realm should automatically infer when it is profitable to do gathers for bulk transfers of data and then scatters at the destination for sparse data movement. This is often more efficient than moving …