-
I know this isn't really an issue, but I needed a place I can discuss with you directly.
As you already know the latest ATmegas and ATtinys are completely different than anything we've seen before,…
-
Hello
Today I got my Rev E rebooted.
As suggested I tried to flash the firmware as the installed is just for shipping!?
I can connect to the Rev E on Mac, Linux and even on Windows.
I can ge…
wk-it updated
5 years ago
-
Device never goes to DFU mode -- I have to flash it with external programmer.
Neither holding button nor sending "UPGRADE" over serial work -- it still boots in normal mode.
I have Chinese RevE …
-
DESCRIPTION:
The seconds counter (or Ready to Launch pattern) can skip a count when you rub the glass.
IMPACT:
While not catastrophic, this sucks because it skips are jarring to the user and wou…
-
Hi i would be really happy if someone could help me out here.
I have been working with some code on different Arduinos for a project at my work. Problem is that two of my Arduinos (Arduino UNO wifi…
-
DESCRIPTION:
A programmed TSL will show “ClockError” some time after it has been programmed.
IMPACT:
This would be a sucky problem if the “clockerror” happened after the unit shipped, or (worse…
-
The XMEGA programmer GUI has some of the logic for programming the XMEGA targets, and it's impossible to make a programmer object without the GUI. It should be much easier to program an XMEGA from the…
-
I just tried to load some code to my Wifi Rev2 and got the following error.
```
/home/builder/opt/arduino-builder/arduino-builder -compile -core-api-version 10611 -hardware /home/builder/opt/ardui…
ghost updated
5 years ago
-
hi,
I have a Chamelon RevE rebooted from lab401.
Running the flash command as provided in the wiki I get:
```
$ ./src/dfu-programmer atxmega32a4u flash --eeprom ~/dev/ChameleonMini/RevE/Firmw…
-
This is more a feature request than an issue:
On a standard Arduino with 16 MHz clock GRBL provides a maximum step frequency of about 30 kHz, when one replaces the Oscillator by a 20 MHz variant, t…