-
```
What steps will reproduce the problem?
1.Add a T54 in Souliss Sketch
2.
3.
What is the expected output? What do you see instead?
T54 it's a Pressure Sensor on Souliss Framwork but show's a Lux Se…
-
Timing issue, in many cases when running node firmata, it will hang.
Happens about 50% of the time.
See below:
I, [2014-10-24T19:25:53.682Z] INFO -- : Initializing connections.
I, [2014-10-24T19:25:…
-
Setup: use_midrc_for_althold=1, throttle input=1500, altitude drifts. Possible cause - insufficent I-term to compensate for thermals, algorithm flaw, barometer problems.
-
i did read #525 which should be included in v1.7.2?- not sure if my board GY271 is really ok.
Checked SDA SCL interchange already.
Set up Ports UART3 = unused, set mag_hardware=2.
This is the only wa…
-
After numerous attempts to build all needed components of esp8266-frankenstein, smoking of all the READMEs and docs in antares, esp-open-sdk, kconfig-fronends and esp8266-frankenstein itself what do I…
-
After 2 and more hours of work DHT example reading loop ( every 2 minutes) I have :
8:17:52.338, connect to: api.thingspeak.com
8:17:52.338, realloc 121 -> 252
8:18:05.993, DNS record _not_ found: a…
-
Hello,
i use STM2 and Stino the first time and i like it VERY much.
Ok, my problem, if i try to build my project, then he dont find a follow methode:
Compiling xtrackballon...
Creating C:\Users\c5…
-
It seems it is not possible to run the more than one BMP180 in the same arduino, with the ability to assign to each sensor it's own address. This would be greatly of help when more than one temperatur…
-
I am using GY-88 module with arduino uno and ide is arduino 1.0.6 .
I am relatively new to this any help will be greatly appreciated.
I get the following error.
In file included from FreeIMU_yaw_pit…
-
Hi guys,
In the FreeIMU.h file, I uncommented the following line:
#define GEN_MPU9250 // Use for Invensense MPU-9250 breakout board
All other lines for different IMUs are still commented out.
How…
ghost updated
9 years ago