-
My heatsink was not mounted to the board with screws. I don't know if this was a manufacturing error or if BTT intends for the thermal adhesive to hold the heatsink in place. After only one week of …
-
GPL requires sources necessary to fully rebuild a binary release be published as part of the release. The "source" tarballs on the release page are just a copy of this repository with no source, link…
-
Treino BTT
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
Using TMC2209 drivers on an Octopus motherboard with a full graphics smart controller. …
-
**Is your feature suggestion related to a problem? Please describe.**
would be much faster to add trackpad gestures, and/or support trackpad scrolling to cycle through windows. similar to windows 10 …
-
[superslicer_support.zip](https://github.com/supermerill/SuperSlicer/files/9690717/superslicer_support.zip)
### What happened?
i noticed the z axis moving while laying down support. then i heard t…
-
Can you add the capability for a Two-finger swipe left-right to map to forward-back button? It will be a nice feature to be consistent with other mac apps and browsers.
-
I'm a bit puzzled...
on the doc https://github.com/bigtreetech/BIGTREETECH-S42B-V1.0/blob/master/42%20Stepper%20Motor%20Closed%20Loop%20Driver%20Control%20Board%20Manual.pdf, there is written that 2…
-
Good day. Does anyone have the latest firmware update for BIQU B1 SKR V1.4?
-
First off, thanks for your work on this :)
Here I have an example print, PETG, printed at 235/80 with no fan, 50mm/s. I'm using Cura, Octoprint and arc welder with the CR6 community fw on a BTT SKR…