-
The kernel you reference to is outdated and leads to certificate errors. Choosing another kernel leads to endless problems with devicetrees and your BBBMini cape. Please update your repository as it i…
-
Hi Folks, I would like to know how to target the STM32F405RG6 or other MCU . Is there a guide to do this ? or is it assumed knowledge? I've no been able to find the details in the documentation.
…
-
Can you enlighten how to emulate the keypad.
I scanned the can data that the keypad is transmitting via my peak can interface.
Found that the keypad is transmitting a heartbeat at ID1805 with 1 byte…
-
Hi,
Klipper is probably 3D printing's most advanced firmware.
It is a two part system where the hard math is done on a real computer, and the real time stuff is done on a microcontroller.
A s…
-
### System information
- **OS Platform and Distribution (e.g., Linux Ubuntu 18.04)**:Linux Ubuntu 18.04(host)
- **Apollo installed from (source or binary)**:packake
- **Apollo version (3.5, 5.0, …
-
I have a standalone automotive ecu with obd2 can bus protocol and i can change the baud rate speeds on the fly.In the other hand i use an esp32 with built in can bus controller to read the PID (RPM,VS…
-
I am quite new to this, is this sniffer .ino file for loading to Arduino uno to work, but what is the mcp2515.CPP and mcp2515.h file for? How should I use this code to work to read the canbus signal? …
-
Hello,
I have got still trouble with setting Filters and Masks when other Nodes are sending messages very fast:
My Shield is using in industrial application and I do not have influence if other nodes …
-
- **OS Platform and Distribution (e.g., Linux Ubuntu 18.04)**: Ubuntu 20.04
- **Apollo version** : 7.0
### Steps to reproduce the issue:
- I run Carla 0.9.6 in a container
- I run [Carla-Apol…
-
Hi! Hope I can get some direction and pointers. I've exhausted the debugging options I can some up with on this. My Arduino/ESP32 knowledge is fairly limited.
But I'm trying to modify this and add …
cr08 updated
21 hours ago