-
Flashing my BlueJayF4 revision 3 with iNav (1.7.2) makes it unusable and one has to use the boot button to reflash it (back to Betaflight). It doesn't respond on the USB port (i.e., there's no `/dev/t…
-
The DataFlash of the NAZE32 appears as missing with the latest code of cleanflight and cleanflight-configurator.
I don't know if it's a problem of the firmware or the configurator.
To reproduce…
-
As the subject already says, the current version of cleanflight is missing the MAG which was detected by older versions of cleanflight.
I don't know if i want to use it but in the near future, but i …
-
A couple of weeks ago the cleanflight configurator was working fine, but that afternoon when I went to launch it, it kept crashing chrome. It was coming up with a note about latest version needing per…
-
At some point in recent history, `BEEBRAIN` no longer fitted in the board's flash memory. Consequently, BLHeli support was dropped in b1844eb5f90bd2d8ea5eff8c50499acf5f99843e, perhaps under the assump…
-
It currently opens the browser to 'https://github.com/cleanflight/cleanflight/tree/v2.0.0/docs', with a 404 message 'This is not the web page you are looking for.'
ghost updated
7 years ago
-
Hi Boris,
Appreciate all the work you do. In 2.5.3, after a successful flight and coming in to land in essentially a hover, the quad flipped upside down and went full throttle in to the ground. I fig…
-
Hey so I can't send RC commands but I can set motor values because I dont have DYNBALANCE included. Since I am using cleanfliht and not MultiWii code, where should i comment out "#define DYNBALANCE" i…
-
Hi there,
I noticed that the BB log transfer is extremly slow on INav compared to Betaflight.
5900 KB takes to transfer with:
INav 1,7 ~ 29min
BF 3.1.7 ~ 10min
I tested this on two different qu…
-
The beeper is not working in the NAZE32 REV6 with default values in CleanFlight 2.0. I've seen that the default values have this settings:
```
set beeper_inversion = OFF
set beeper_od = ON
```
In…