-
I'm absolutely loving the new toolpath preview feature - it's a big timesaver when sanity checking generated prints before starting them.
I did notice, however, that brim and skirt do not appear to r…
-
I've found that at moderate speeds (50 mm/sec and above), drawing the exterior perimeter first can cause surface blemishes because the filament within the nozzle may not be entirely in position to be …
-
While printing a cylinder with Slic3r 0.9.10b's spiral vase function I noticed my printer starting and stopping some times where the layer change would have been.
Turns out there are some gaps, and on…
blddk updated
6 years ago
-
I ran into an interesting edge case last night. Just as my printer transitioned to the 2nd layer, and the cooling fan turned on (for PLA), I noticed in the log from Pronterface that the cold extrusio…
-
#### If this is a feature request describe it here
FEATURE_REQUEST_DESCRIPTION_GOES_HERE
#### Version of Octolapse
Octolapse Version: 0.3.1
#### Version of OctoPrint
OctoPrin…
-
I'm consistently having a really wierd slic3r issue on sharp corners. Slic3r will add little bits extruding from the corner only on some layers - see here:
![image](https://cloud.githubusercontent.c…
-
Hi,
I've been using Slic3r for a year or so. Just downloaded V1.2.9 and can't get it to work. If I try launching from a terminal, I get
Can't load '/home/glenn/Slic3r/lib/vrt/9e109cfe461eb9a764d581…
-
This is the short gcode header version I get from ver 1.1.1:
; generated by Slic3r 1.1.1 on 2014-04-24 at 09:24:03
; perimeters extrusion width = 0.35mm
; infill extrusion width = 0.52mm
; solid infil…
-
It gets blocke when exporting gcode for any STL
; generated by Slic3r 0.9.9 on 2013-04-07 at 10:32:41
; layer_height = 0.15
; perimeters = 3
; top_solid_layers = 0
; bottom_solid_layers = 6
; fill_d…
-
This causes a flicker effect and in the worst case an infinite loop (only way to escape is by jumping).
The two root causes:
PlanetariaRigidbody.position is set without setting PlanetariaTransform…