-
The POW R2 sends the mqtt messages and I can see them arriving in the debug log of the sonoff adapter:
: yaml
What I am doing: i'm using card-mod into a custom:co…
-
Hi folks,
I'm trying out this component and I'm able to see my Sonoff POW as device, and it is reading it's initial values for Amps, Volts, Watts, etc. however... if the state changes (e.g., the lo…
-
### What happened?
as shown in attached screen, after updating zigbee2mqq to version 1.37.0, the ON/OFF switch disappeared from home assitant!
It remain visible and working only into zigbee2mqtt f…
-
### What happened?
I have eight Bticino N4027C purchased all together a few months ago. I installed two of them immediately and they showed the tilt position. Now I'm installing the other six, but I …
-
Hello,
i have flashed my Sonoff-E with the newest Router-Firmware Update 2 and now the Sonoff is unknown and has a new Zigbee-Model Name. Instead of DONGLE-E_R it is now DONGLE-E.
![Sonoff E Route…
-
### What happened?
I have (a lot) of SONOFF ZBMINIL2 devices: https://www.zigbee2mqtt.io/devices/ZBMINIL2.html. I found out the firmware of this device does not (currently) support genGroups, so it w…