-
Hi,
Really like this project.
Do you think it would be feasible to support a wider range of voltages, up to 48V or 60V for use with large machines and motors?
-
jumpers double checked under the driver module, no idea how to continue?
-
The electrical circuit needs some voltages to work:
- +15V and -15V for op-amps (~70 mA @ -15V, ~100 mA @+15V) and LEDs (~500 mA)
- measured on +15V: 290 mA with 2 channels (with vu meter on 15V) …
-
Hey, would you be kind to share the schematics for the A6211 driver? I’ve been thinking about designing a 5 channel pcb for a string of 16 Cree leds, 8 leds , 4 leds , 2 leds and the last string of 2 …
-
Hello! I used your firmware to improve engine performance, and I have a question about the firmware parameters. I mainly use assistant levels 2 and 3 on the stock engine and differentiated the levels …
-
I had the countdown leap year issue, so I decided to open the watch upgrade the firmware when I heard of the solution, something I haven't done for nearly a year. I also decided to put nanosec, finetu…
-
### Is your feature request related to a problem? Please describe.
The existing implementation to set the motor current is as per the TMC datasheet.
- CS (current scaler, IRUN_IHOLD) is set to 31 (m…
-
Two 5160 pro at 48v 2.8a running nema 23s.
When jogging the dimensioning held up nicely but while printing the dimensioning started to fail (ie needed 45mm but went 43mm). Eventually one of the m…
-
Hv batteries are always more than 24 cells in series. How did you get it to work with the BMS when it only have 24 outputs for cell balancing? Did you use active balancers and how did you wired them i…
-
Great work on this, I managed to use it to pair to my 100ah lithium battery via the hub from my laptop. Great little starter kit to build a monitoring dashboard.