-
Hi,
Is there any chance to build Backup/Restore function of the Controller into OZW? As I understand it if the Controller goes dead you cannot restore your Nodes into a new Controller!?
A nightmare …
-
Hi all!
I have a problem with device parameter input.
The Neo Z-wave Repeater parameters id 3 & 4 (temp- & hum offset) range is -120 ~ 120 according to manual.
Setting a positive value saves ok but…
-
### Describe the issue you are experiencing
After upgrading to 12.3 my HA started bootlooping. Noticed that after I disconnected my Aeotec Z-Stick ZW090 it booted again and ran fine (without my Z wav…
-
Для добавления поддержки нового устройства в хаб, необходимо:
AEON Labs - UnknownNode Id5Manufacturer Id0086Device Type1A02Device Id0082App Version2.3Basic ClassRouting SlaveGeneric ClassWall Control…
-
**THANK YOU** for working on this plugin. I am seeing this in HomeBridge's log (_rpi3, running the homebridge image_).
Aeotec Gen5 stick.
```
[19/03/2021, 16:06:43] [homebridge-openzwave] This…
-
### Checklist
- [X] It is not in the [configuration DB](https://devices.zwave-js.io/?search=3)
- [X] It was not [merged recently](https://github.com/zwave-js/node-zwave-js/pulls?q=is%3Apr+is%3Aclose…
-
I’ve added your app on homey and the plug functions fine with different meters. The issue here is that homey shows it as a light. When checking the zone it shows that there is a light on. I can only a…
-
In my setup both in combination with another thermostat, and as standalone, the VThermo sometimes fail to switch off the Zwave controlled heater. VThermo has heating "switched off" but the Zwave smart…
-
Hi, I' running the latest Windows build, 104. I'm having trouble setting a config value for all of my Aeotec Smart Switch 6 devices. I'm able to adjust other values, but not 'Send Interval for Report…
-
I have one raspi with 3 Aeotec Home Energy Monitor's (Gen2) and I am recording the kWh and W for each of the sensors via the influxdb module. I have seen some spurious data - where avery now and then …