-
### Description
I just flashed my XY-3 Pro. Because there wasn't a prewrote "#define" for my printer I had to get creative In config.h I used the
XY-3_V5_330_NO_TITAN_TMC_NO_ABL
I changed the fo…
-
This firmware has the following issues:
- Auto bed leveling skipping the initial steps, completely ignoring the button and silicone pad at the back.
- The settings button during prints only controls…
-
My z-probe is offset 30,10,5mm - so it's above the nozzle.
So I use 3-point auto leveling and use 3 spots where the nozzle is outside the bed, but the zprobe is not.
I have defined my "Z-probe-heigh…
-
Hi, I just recently purchased SKR 1.3 and TFT 35 V2.0 Finally today started working on it and changed it from MKS GenL with stock Ender 3 display to this one and now I can not enable mesh bed levelli…
-
Why didn't you set the probe offset correctly ?
https://github.com/weedo3d/TINA2firmware/blob/b174e156a8cd876b259e2f5bd1e189c502f7d17e/Marlin/Configuration.h#L542
atsju updated
2 years ago
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
Tested in Ender3v2 with the last bugfix:
Do an auto home (G28) and wait to finish an…
-
### Description
Autoleveling bed fails after first touch point. No errors on LCD.
### Steps to reproduce
1. Try to autolevel from printer
**Expected behavior**
Autolevel hits 25 points…
-
Any updates on this?
https://github.com/makerbase-mks/MKS-Robin-Nano-V3.X/issues/73
-
Hello,
I have a Cartesian printer on which I set up auto bed levelling. The bed is 200x200mm, for testing it is about 0.5mm non-level. The probe is a Misumi contact switch driven by a small Maxon mot…
-
after 4 mks 35 with s base we have:
1) issue when you have Z max endstop and use bed leveling by 4 point from tft, when bed already at home and you choice any point, printer try move down anyway on 1…