-
Hi,
It would be nice to be able to map some properties as labels to help identify devices which publish to a single topic.
I have a use case with `rtl_433` which is collecting weather station da…
-
**Describe the solution you'd like**
It would be great to have the ability to set colour thresholds for battery levels in the entity-card, so that the battery icon can change colour depending on cu…
-
Power system topology should allow it to be isolated so that the board may be used with an external EPS
Blocking #1
-
**Is your feature request related to a problem? Please describe.**
Would like to have WipperSnapper installed outside with a solar setup (still within wifi range) for a wind gauge, anemometer, and ra…
-
Hi Martin,
Thanks for all your work on this project.
Just a couple of question;
1. Does the firmware support a float mode setting?
Float mode with say an 8 hour timer would allow the mppt to stay …
-
Esp32 can tell what was the cause of deep sleep wakeup. This is being used already internally to figure out different timeouts based on the cause, but it would be nice to expose this to an automation …
-
This also applies to batteries wattage counter, but these numbers are completely meaningless. The amount of heating caused by a wire (and how much current it can handle) is based on energy lost throug…
-
Hello, I have an iPhone4S with a broken battery, so I replaced it with a third party one and now im unable to restore it. I even threw the old away! So any help will be nice! Also, as it does not have…
-
**Is your feature request related to a problem? Please describe.**
From what I understand, lithium batteries wear out over time, and [using and storing lithium batteries at full charge (e.g. 4.2v) ca…
-
Hi :)
I have a question regarding the max current output of the PiJuice Zero, as I need a remote power source for a Zero W that makes use of a sixfab LTE Hat.
At [pi-supply.com](https://uk.pi-sup…
jan94 updated
3 years ago