-
Update to new firmware Now won't load filament Screen pop up set temp to 200 click ok and nothing happens
-
Hello everyone!
Is it possible to make the firmware compatible with another STM32 MCU's?
The STM32F103VCT6 is a little expencive but STM32F103C8T6 for example if only a couple of euros.
Al…
-
Add a screen off button. In order not to wait for the backlight timer to expire. Just pressed the touch button on the screen and the screen went out, then touched the screen and it turned on, just lik…
-
Hello,
I am trying to make this library work with ESP32-S3 and BIGTREETECH TMC2209 1.3 UART drivers.
https://www.amazon.com/BIGTREETECH-Printer-Stepstick-TMC2209-Heatsink/dp/B07YW7BM68/ref=cm_cr_a…
-
Make a battery status indicator. To prevent complete discharge when using it. You'll also be able to see when it's charged, so you can remove it from the printer and walk away with it.
I'm not talkin…
-
Some recent versions of the BTT TFT Touchscreens (https://github.com/bigtreetech/BIGTREETECH-TouchScreenFirmware) make use of the GD32F205VC MCU so this project should consider adding support for thes…
-
I'm totally revamping my new in box E5+, has anyone successfully ran one of the above mentioned boards or any of the BTT boards without a TFT screen? My current 5+ is running in my print lab with a bi…
-
SKR1.4-Turbo
UPS V2.0
Relay v1.2
TFT E3 v3
I bought such a set. Installed, connected, configured Marlin. Added M81 code to the end of the print. After the end of printing, the printer writes "sh…
-
Hello, is it possible to address the power and the USB interface externally via an API/ webhook? This would make it possible to integrate this switch into a smart home such as HomeKit or Home Assistan…
-
[{
"resource": "/c:/Users/Tim/Downloads/BIGTREETECH-OCTOPUS-V1.0-master/BIGTREETECH-OCTOPUS-V1.0-master/Firmware/Marlin-bugfix-2.0.9.2.x/.vscode/c_cpp_properties.json",
"owner": "c:\\Users\\Tim\\D…