-
Do i need to change anything in the code to run on a arduino uno?. for the AHRS BMP280 code?
-
Hello
How can I set the baro altitude or reset it before takeoff? (Heltec v2)
Now:
GPS: + 87.3 m
Bmp280: -78.5m (1022.75hPa)
Thanks!
-
The BMP280 sensor must be protected against liquid ingress, but it's possible for the water in the bottle under some circumstances to reach the sensor. We should test how the responsiveness is affecte…
-
We need to create a driver to interface with the BMP280. This would let us know if our barometer is working as expected.
-
### The problem
I have connected a BMP280 module to an NodeMCU Lua Lolin V3 Module ESP8266 ESP-12F WIFI Wifi Development Board and can see it over i2c but don't seem to get any temperature or pressur…
-
Comparing manifests for raspberrypi0-2w-64 2.87.16+rev1 prod and raspberrypi3 2.83.21+1 prod it looks like the following are not included in the Zero 2:
```
kernel-module-bmp280-5.10.31-v7 raspberry…
-
Hello Fabien, I just received pcb from pcbway. Thanks for your job. I notice you with my progress!
I wait from bme280 sensor.
I use the same pins as BMP280 (you have a graphic with this)?
Thanks…
-
Is it possible to make weather forecast in plugin?
Like here:
https://www.mysensors.org/build/pressure
BMP085, BMP280, BME280 also.
-
-
### Describe the bug
The bosch,bmp380 family of iio sensors is supported in the 6.1.21+ kernel, but it is not supported by the i2c-sensor device tree overlay.
```
# dpkg -S /boot/overlays/i2c-se…