-
For the next generation PCB, we're looking at switching away from the Atmega328p, since it is becoming too small for future additions (see also #2). This issue summarizes some of our previous consider…
-
-
Hello,
I recently purchased 5 of these modules from ebay ([https://www.ebay.de/itm/285579711444](https://www.ebay.de/itm/285579711444)) and I can only get one half of the display to light up when I…
-
I want to add 2.5Gb ethernet card to my chromebox. I added it and it doesn't work.
Some information about system:
firmware-util.sh output:
```
** Device: Asus Chromebox 3 / CN65 (TEEMO)
** …
-
how about this board? do you have any idea how to develop a firmware for this board?
https://ae01.alicdn.com/kf/S601617b6ba85423580d4ebbea6135bbb5.jpg
-
There are several open issues that all seem related to wifi being broken on esp32 s3 and c3, seems to work on the latest esp lib. Not sure if its a combination on wifimanager starting and stopping sta…
-
Hi Kristoff,
Have you thought about implementing an RX feature? I'm considering doing this for DapNET, as an alternative to commercial pagers...
Regards,
Manoel - ON6RF
-
> ISP connector ... not the standard one as I wanted a sixth pin ... hooked up to 3.3V so I have a target voltage reference for my UART interface. Never a good thing to drive UARTs on SoCs if the SoC …
-
Not sure if this has been requested before, but would it be possible to add a secondary MQTT Host + Port to Tasmota?
If primary MQTT host fails, retry the secondary MQTT host.
Just a nice to hav…
-
Hi everyone
Anyone has luck with LED panel using [CHIPONE's 2153](https://olympianled.com/wp-content/uploads/2019/11/ICND2153_datasheet_EN_2019_V1.2.pdf).
I'm using this driving board: https://www…