-
I printed the compressor and the housing and while the wheel came out fine the housing needed pretty elaborate supports that left a pretty mangled surface for the wheel to come near which needed a lot…
-
If the disable_interface option is set to true in /opt/ros/kinetic/share/qt_robot_interface/config/qtrobot-interface.yaml it seems the robot does not fully shutdown when the shutdown button is pressed…
-
Would be great to have more detail on how to wire up the ESC/IR/Trinket for beginners like me and my son. Your sharing is valuable, thank you.
-
**Is your feature request related to a problem? Please describe.**
Když mi běží poslední tisk, tak po dotisknutí mi tiskárna vychladne a filament mi zůstane uvnitř, a ten musím pak buď ustřihnout, an…
-
**Describe the bug**
Its rather feature request than bug.
Option to keep fan spinning for some time before it will stop would be good.
For example:
I generally have silent desktop pc which is d…
-
So I recently installed the E3 turbo on my Ender 3 V2 and it has been working great everything works until I tried to print this carbon fiber filled polycarbonate blend.... 90 c bed temperature and 26…
-
I have successfully installed the card on my Ender 3 Pro, I started to print correctly configuring language, bltouch and all the changes that interested me, after about 18 hours of printing (discontin…
-
Hello,
I want to configure my OpenSource 3D printer with these following electronic parts :
Power supply 220V AC / 30A (360W) - 12V DC
Heatbed 300x300mm - 220V AC / 500W
Solid State Relay SSR-…
-
**The Problem:**
Let me tell you a charming story of melting plastic and destruction… (pics below)
I have an “Ender 3 V2” with the OEM CREALITY control board and OEM Marlin.
I was using it to …
-
### The problem
The switch interlock should use the interlock_wait_time as a means of preventing *any* changes to GPIOs in an interlock group within a certain amount of time since the last change.
…