-
I have tried to port spi+NG solution to my board. I use 1.0.3 version,but it does not work.
host side log:
root@myd-y6ull14x14:~# insmod esp32_spi.ko resetpin=44 raw_tp_mode=1
[ 62.261172] esp32…
-
Reference: https://github.com/tianocore/edk2/tree/master/OvmfPkg/RiscVVirt
Note that EDK 2 support both ACPI and FDT hardware definitions, so existing FDT generation should be fine. Some NVRAM emul…
-
hello, first of all, thank you for the effort and your amazing work
I can modify a kedei 3.5 rpi screen perfectly
but when I try to modify a cheap Aliexpress rtd2660h board controller I can write…
-
Recently I got some requests about problems with upgrading the firmware using an USB-Blaster. Instead of using e-mails I would like to collect the relevant information into this thread. Maybe this cou…
-
I tried to compile these sources. I have previously installed the xc8-v2.36 and MPLABX-v6.00 compiler. I used the virtual Ubuntu_22.04. I run the "make" command.
As a result, the 4.5 kb file fw.produ…
-
I was able to properly flash the MCU with the latest passthrough firmware. This is my ESPHome config: https://pastebin.com/p22yFTiz
I can capture the original remote successfully, I think:
[13:34:…
-
Root password that exported from the ZyxelRoot.py doesnt work , I have V5.50(ABRV.2)b9 software
-
Hello, we're excited to share that our company has developed a four-in-one ESC featuring the AT32F421K8U7 chip. We're reaching out with a question: Could you kindly advise us on how we can integrate y…
-
### The problem
I received a notification from the La Marzocco integration that the Gateway Firmware has a newer version available. However, the newest version (v3.4-rc5) is older than the installed …
-
Hi,
I'm trying to flash an RBR50 ( with USB port so i assume v1) but the mac is cleared it seems.
I keep getting this no matter what, "Timeout while waiting for ACK(0)/OACK"
I've tried 10.0.0.1, …