-
![WhatsApp Image 2021-10-16 at 13 48 26](https://user-images.githubusercontent.com/92641963/137595710-7d992817-45f0-4cf7-ba3b-c7097ef32e10.jpeg)
Hello how are you? I'm having a problem with the MINI …
-
In description it says that this board support marlin 2.0 but neither marlin repository nor this one contains configuration for this board. Is there any instructions on building marlin firmware for th…
-
Recently bought a new FYSETC E4 board, plugging it in doesn't create any wifi so I can update the firmware. Also I don't know how you can put the ESP32 in download mode to upload a new firmware. How c…
-
Followed the instructions 100% but no matter what I try it doesn't connect (also tried multiple cables also; it flashed fine with the first cable). Klippy.log errors below.
PIS.cfg...
[mcu PIS]
…
Ltek updated
7 months ago
-
There is a problem with NIS updating to newer klipper
`make flash FLASH_DEVICE=0483:df11
Compiling out/src/pwmcmds.o
Compiling out/src/lcd_st7920.o
Compiling out/src/lcd_hd44780.o
Compi…
-
Hi,
is it possible that fysetc provides a rrf 3.4 image for the spider board?
That would enable the users to use can bus.
greetings
Daniel
-
### Wiki Search Terms
I am using FYSETC E4 board, dual Y-axis motor with 2 end switches. the $limits reports that the switches are working correctly Motor0 is reported as Lower y and motor1 as uppe…
-
getting compile error: Marlin\src\HAL\STM32\../../inc/../HAL/STM32/inc/SanityCheck.h:42:4: error: #error "Disable PRINTCOUNTER or choose another EEPROM emulation."
-
Feature request about future hardware revision. Not sure if this is possible via software change only on current hardware.
Fysetc sd wifi card device is very close to capabilities to sdwire project…
-
In the step file for v2.1 RGB display, the reset button is not included - which makes it hard to determine the exact position.