-
**Describe the bug**
Laser GRBL will try for a long time to connect and then give a generic "Error connecting to your machine" message. The com port shows up when the machine is plugged into the USB …
-
-
Hello, I just tried out this wifi based method, and after some minimal corrections in the code, I managed to make the system work. After using the engraver quite a lot, I found out that there are appe…
-
I have a DIY laser engraver which I built using an old 3D printer frame and parts, a UNO with a CNC Shield and a 5.5W diode láser. I flashed it with GRBL 1.1 and I am using LaserGrbl. Once I had it wo…
-
**Describe the bug**
when the soft limit is enabled, double-clicking on the selected XY location does not work. the laser start run up at the top right and stops by hard limit. if the soft limit is s…
-
LaserGrbl v3.8.9.0
Grbl v1.1f
Wrapper: UsbSerial
Win 7, Ultimate, 6.1.7601.65536, Service Pack 1 (0)
CLR: C:\Windows\Microsoft.NET\Framework\v2.0.50727\mscorlib.dll 2.0.50727.8806 (QFE.050727-8800…
-
Hi I have problem because all laser are controlled by TTL 0-5 V but on max power grbl on Arduino Uno and cnc shield on pin D 11 giving only 2V so don't think use all my laser power.Is any way to incre…
-
Hi Lee,
First I wanted to thank you for your extension, I used it over a year, and made great project.
It was perfect for my NEJE desktop laser engraver
Unfortunately after i installed another ext…
-
Hi, with my laser engraver (Vigotec L7) i used VigoEngraver Software, now i'm using LaslerRGBL and is awesome sofware, but is missimg one of best option in this, engrave by point,
![Cattura](https…
-
My limit switches seem to be extremely sensitive to electrical noise. I had everything set up on my cnc laser engraver, all wires run through the cable chain and plugged in to my arduino with a shield…