-
Hi,
I just got the nefit easycontrol device and I'm trying to get it to work with your software.
For the app to work I had to register the device on the Bosch website, there it now lists it with a…
-
Hello,
When I send a value of 5 degrees to "HeatingTemp" via the EMS-ESP gateway (v3.4.4), it jumps and the "SelFlowTemp" to 30 degrees.
This means that the boiler, at a sufficiently low supply …
-
Does anybody know if the 'outdoor temperature' sensor of the Trendline boiler is exposed on the EMS/MQTT bus?
regards, Harry
-
**Question**
The EMS-ESP32 gateway can report shower time. How is this determined?
I have a shower, a bath tub and a sink faucet. How can the controller know it was the shower?
-
Just noticed this in log today
Running HA 2022.12.0 and Nefit Easy v3.0
Googled and found similar issues on other integrations. General advice was that it's no big deal an can be ignored. Not sure…
-
Hi,
I had some problems with the add-on in the past month, worked great before (thanks!) but HA could not connect to the Nefit Easy.
So I installed the add-on again today. Unfortunately I get th…
-
Hello,
I have a Nefit Trendline HRC30 CW5 boiler, with an EMS-ESP gateway with firmware v3.4.4. It is possible to adjust the "pump delay" and the "burner min period" through the EMS-ESP gateway. Ho…
-
Guys first installation and I keep getting "Unknown error occurred".
Using Nefit Easy (CT100).
Nefit Easy Bosch Thermostat integration works.
Any advise where to start troubleshooting?
-
I've implemented your code, (compiled with Qt on Ubuntu)
but the program output is:
tarting /home/bram/build-nefit-easy-Desktop-Debug/nefit-easy...
DEBUG: connected
get /system/location/latitude…
-
I have updated to dev.3.7.0 as a test,
after a certain time n 1-3 hours the ems-esp is no longer available, no response, no putty, no ping
the whole thing can be reproduced, if I switch back to dev …