-
Hello,
To save doing callouts for translation updates via releases; going to try having everyone who would like to be notified when there is going to be a release so that they can do a translations…
Ralim updated
3 years ago
-
Has anyone tried this with the DPH3205 which is the buck-boost converter version of this?
-
I'm getting a simmiilar error on linux (linux/nixos/wayland/sway) where it starts fine for the first time and crashes if i start it again after that.
With Rustbacktrace:
```
thread…
-
I have successfully updated the firmware, but when the soldering iron reaches the desired temperature it goes into standby mode (and thus cools down again)
This happens every time I try to go into…
-
**Support for Sequre S60**
im not sure if it is possible or not to support IronOS on the Sequre S60.
I recently added this soldering pencil to my bench as a companion to a TS80.
The S60 is sh…
-
Hi, im havinhg some troubles with the buttons.
pla+ one week of use were enoght to break some
petg is hard to put them (those little thingys that secure them on the switch breaks a lot)
any tip…
-
**Describe the bug**
When using the ```/Set``` prefix , I am able to set values once. On most occasions , when trying to send a second ```/Set``` the BLE side fails. I do have a suspicion that this…
-
Hello,
I followed the guide using the `dfu-util -d 28e9:0189 -a 0 -D Pinecil_FR.bin -s 0x08000000:mass-erase:force` command, but with the `mass-erase:force` option dfu-util doesn't work, it gets th…
-
Hello there! Thank you for making this so easy to integrate into HA! Unfortunately I'm running into a problem when trying to add my pinecil. I looked at your PinecilWrapper class and it seems to have …
-
Hi, I seem to have bricked my TS100 using release 0.2. I'm not sure what's gone wrong since everything seemed to proceed as in the instructions. I first installed `runtime.hex` using stock mass storag…