-
Does this button still exists? I don't see it on the home assistant overview. Below is my config
Switch to enable or disable SenseAir S8 CO2 sensor Automatic Baseline Calibration (ABC)
```
`da…
-
Hello to all,
thanks to your suggestions I have carried out continuous monitoring using OPC-N2. For two months the data were collected without any kind of problem.
Recently I realized that for 1…
-
I have seen a couple of times that a device has some "unreal" sensors in it.
![image](https://github.com/fablabbcn/smartcitizen-api/assets/13301321/2ea31399-7aba-4ec6-bbb9-4a4301bf9dbb)
I don't …
-
This was discussed at length in the past, and prototyped with early code of this uasyncio. There is known demand for it in high speed UART applications and audio processing. Salient points:
- Enabl…
-
### PROBLEM DESCRIPTION
_A clear and concise description of what the problem is._
I have an air quality sensor that uses a Senseair S8 CO2 sensor. The sensor is detected correctly when the dev…
-
Have a new station using SPS30.
On the measurments I get PM1&PM2.5&PM4&PM10 readings.
Issue is that the PM2.5 and PM10 readings are most of the time the same or only differ by 0,1µg/m³.
Only PM1 se…
-
Hello, I was currently reviewing where the PM compensation is applied throughout the code, and found something weird:
The script AgValue.cpp is calling the compensate method of the pms5003t objects…
-
I noticed that [recently the US EPA updated the AQI formula](https://www.epa.gov/system/files/documents/2024-02/pm-naaqs-air-quality-index-fact-sheet.pdf). They changed a few of the breakpoints, such …
-
# Problem
Attempting to compile in the Arduino IDE results in the following error:
```
/home/user/air_gradient_open_air_firmware/examples/OneOpenAir/OneOpenAir.ino:40:10: fatal error: AirGradient…
-
Do you have a Dockerfile that does not require balena and works standalone ?